Connecting your personally owned device to BlazerPrint (Students)

The following instructions will walk you through the process of setting up the 'BlazerPrint' virtual printer queue on your personally-owned laptop. Once set up, you can send print jobs to the queue and release them from any BlazerPrint copier on campus.

NOTE: These instructions are designed for personally owned devices. MCLA Faculty/Staff who are using MCLA-owned devices should review these instructions instead.

For Windows Users:

• 1. Ensure your laptop is connected to the oncampus MCLA network, preferably Eduroam.
• 2. Download the Mobility Print Installer located here.
• 3. Run the installer once fully downloaded.
• 4. Windows prompt will ask you for permission to make changes to your computer; Click “Yes”
• 5. Select a language, then click “Ok”

• 6. Click “I accept the agreement” then click “Next”

• 7. “BlazerPrint” should appear in the list of printers. Select “BlazerPrint”, then click “Next”

• 8. Sign in using your A number and password, then click “Next”

• 9. If done successfully, a page will appear saying that the Mobility Print Setup has been installed. Click “Finish”

• 10. BlazerPrint should now appear in the list of printers when attempting to print

For Mac OS Users:

• 1. Ensure your laptop is connected to the oncampus MCLA network, preferably Eduroam.
• 2. Navigate to System Preferences > Printers and Scanners.
• 3. Click the ‘retry’ icon under the Printers List. The Add dialog is displayed. It displays a list of all of the discovered printers on the network.
• 4. Select a "BlazerPrint' printer that uses the Bonjour protocol.
• 5. At the bottom of the dialog box, check that Use is set to Secure AirPrint.

Note: If Secure AirPrint isn’t displayed, close the add dialog then disconnect from the network. Reconnect to it again.

• 6. Click Add.
• 7. Print your document. When prompted, enter your MCLA A number and password.